Respirator Cleaning Procedure
Introduction
These procedures are provided for the repirator user to use when cleaning respirators. They are general in nature, and the employee, as an alternative, may use the cleaning recommendations provided by the manufacturer of the respirators used by their employees provided such procedures are as effective as those listed here. Equivalent effectiveness simply means that the procedures used must accomplish the objectives set forth in the Respirator Cleaning Procedures must ensure that the respirator is properly cleaned and disinfected in a manner that prevents damage to the respirator and does not cause harm to the user.
Procedures for Cleaning Respirators
Instructions
Remove filters, cartridges, or canisters. Disassemble facepieces by removing speaking diaphragms, demand and pressure-demand valve assemblies, hoses, or any components recommended by the manufacturer. Discard or repair any defective parts.
Wash components in warm (43 °C [110 °F] maximum) water with a mild detergent or with a cleaner recommended by the manufacturer. A stiff bristle (not wire) brush may be used to facilitate the removal of dirt.
Rinse components thoroughly in clean, warm (43 °[110 °F] maximum), preferably running water. Drain.
When the cleaner used does not contain a disinfecting agent, respirator components should be immersed for two minutes in one of the following:
Hypochlorite solution (50 ppm of chlorine) made by adding approximately one milliliter of laundry bleach to one liter of water at 43 °C (110 °F); or,
Aqueous solution of iodine (50 ppm iodine) made by adding approximately 0.8 milliliters of tincture of iodine (6-8 grams ammonium and/or potassium iodide/100 cc of 45% alcohol) to one liter of water at 43 deg C (110 deg F); or,
Other commercially available cleansers of equivalent disinfectant quality when used as directed, if their use is recommended or approved by the respirator manufacturer.
Rinse components thoroughly in clean, warm (43 °C [110 °F] maximum), preferably running water. Drain. The importance of rinsing cannot be overemphasized. Detergents or disinfectants that dry on facepieces may result in dermatitis. In addition, some disinfectants may cause deterioration of rubber or corrosion of metal parts if not completely removed.
Components should be hand-dried with a clean lint-free cloth or air-dried.
Reassemble facepiece, replacing filters, cartridges and canisters where necessary.
Test the respirator to ensure that all components work properly.
Program originated August 1, 1999
Reviewed by Risk/EH&S 11/2026